1.測量確認尺寸：在開始制作之前，需要先確保長廊的尺寸，包括長度、寬度、高度等，可以用卡尺進行測量。同時，需要考慮到長廊的售價、定制等等因素。

1. Measurement to confirm dimensions: Before starting production, it is necessary to ensure the dimensions of the corridor, including length, width, height, etc., which can be measured using calipers. At the same time, it is necessary to consider factors such as the price and customization of the corridor.

2.制作木質設計拼裝件：仿木長廊中還需要一些木質設計拼裝件，這些件的數量和大小要根據長廊的實際長度進行確定，通常需要使用錘子、斧頭、手鋸等工具進行加工。

2. Making wooden design assembly parts: In the imitation wood corridor, some wooden design assembly parts are also needed, and the quantity and size of these parts need to be determined based on the actual length of the corridor. Usually, tools such as hammers, axes, and hand saws are needed for processing.

3.安裝鋁合金連接件：將鋁合金連接件按照三角形的布局形式安裝在地面上，確保其已經卡在地面，然后將其分解成兩個三角形組件，再使用螺釘將其固定在地面上部分。

3. Install aluminum alloy connectors: Install the aluminum alloy connectors on the ground in a triangular layout, ensuring that they are already stuck in the center of the ground. Then, decompose them into two triangular components and fix them to the ground using screws.

4.安裝仿木板：安裝仿木板需要按照一定的尺寸和順序進行。，在その1的鋁合金下部安裝仿木板，然后通過諸如角碼、螺釘、等工具將其連接到三角形鋁合金連接件上。當連接件與仿木板準備好時，需要確保其牢固性及其與鄰近板的及時連接。

4. Installing imitation wooden boards: Installing imitation wooden boards requires following a certain size and sequence. Firstly, install a simulated wooden board under the aluminum alloy of そ 1, and then connect it to the triangular aluminum alloy connector using tools such as corner codes, screws, etc. When the connectors and imitation wooden boards are ready, it is necessary to ensure their firmness and timely connection with adjacent boards.

5.設置屋頂：從外向內，設置屋頂，因為數據材料仿木板的成分制作出來的屋頂是非常精致，并能保護墻壁。然后，需要在屋頂的中部安裝仿木板，并使用角碼將其固定到豁口附近所處的鋁合金板材上。

5. Setting the roof: From the outside in, set the roof because the roof made of data materials imitating the composition of wooden boards is very exquisite and can protect the walls. Then, it is necessary to install imitation wooden boards in the middle of the roof and fix them to the aluminum alloy sheet near the opening using corner codes.